Oxygen Cylinder Mini Scuba Diving Equipment Air Tank &High Pressure Air Pump Set. High pressure air pump. Respirator is made of aviation aluminum: aviation aluminum, standard portable oxygen tank parameters manufacturing, and meet the manufacturing standards of diving equipment. Pressure relief from the top hold down the top to relieve the pressure inside the bottle. Note: the pressure shall not exceed 20 pressures. Regulator: open at any time, breathing balance on demand single regulator, with a pressure gauge, can show how much air. Engineering bite silicone bite safety fit ergonomic design. Condition: 100% Brand New. Material: Stainless steel + aluminum alloy + silica gel + Aviation aluminum. 7330g / 258.6oz. Respirator material: aviation aluminum + silica gel. 13 6 35.2 5.8 cm/5.12.413.92.3in. Specification: 0.5 l. Gas capacity: 3.0 CU FT/85 LITERS. 13.4 / 34 cm. Diameter: 2.25: LB. / 2.25 cm. Maximum pressure: 3000 PSI/200 BAR/20MPA. Number of surface breaths: about 30 (2.5 LITERS per breath). It can breathe about 57 mouths of air on the surface, and adults can breathe about 21 times under the mouth of water, 7 meters under the water for about 6 minutes! The product contains an inflatable head, which can be directly inflated in a standard diving cylinder and can be fixed on the BCD. The product is portable and independent of the respiratory system. Breathing apparatus high-pressure pump. High pressure air pump material: stainless steel. 62 26.2 3.6 cm/24.410.31.4in. Size when pumping: 106.5cm/41.9in. Step on the opening size: Approx. Connector size: diameter: Approx. 3.1cm/1.2in, length: Approx. Ventilator port diameter: Approx. 65 38.5 10.5 cm/25.615.24.1in. Size of single outer box: Approx. 674113cm/26.421.316.3in. Size of 5PCS in a box: Approx. 675441.5cm/26.421.316.3in. 1 High pressure air pump(Accessories: 1 air pipe, 1 connector, 1 spanner, size 14.850.25cm, 2 packages of accessories). High Pressure Air Pump. Made of high quality stainless steel, anti-rust and durable. High pressure air pump by hand, 53cm/20.9in length air pump tube. It only takes about 6 to 7 minutes to fill a 0.5L oxygen cylinder. With a pressure gauge on it, you can know when to stop inflating. Portable and practical, essential accessory for diving. Color: Shown as pictures. Air Tube Length: Approx. 53cm / 20.9in. Connector Diameter: 3.1cm / 1.2in. Connector Length: 9cm / 3.5in. 1 High Pressure Air Pump (with Connector and Air Tube). 1 Wrench(Size: 14.8 5 0.25cm / 5.8 2.0 0.1in). 2 Packages of Accessories. High-pressure air pump, in the process of air inflating due to up and down friction, resulting in fever, this phenomenon is normal. The phenomenon of oxygen cylinder respirator can’t be inflated: firstly, when oxygen cylinder respirator is delivered, it does not contain gas, secondly, check the high-pressure pump before inflating the high-pressure pump, assemble it according to the instructions, install the gasket rubber ring, tighten the exhaust valve, and then inflate it. This product is different from oxygen pumps such as basketball, volleyball. Effectively, please be patient to inflating for two or three minutes before the pressure gauge will change. It takes three men to inflating about 16 minutes for each oxygen cylinder to fill up. Within 3000PSI, it is within the normal range. Over 3000PSI may burst (please don’t inflating too full). Oxygen cylinder head and body should be checked for tightness, good connection and not standing above the oxygen cylinder when inflating. Be careful not to inflate the oxygen cylinder to a certain pressure. Oxygen has certain impact. Please pay attention to safety. When the pump is finished, please notice that it is dangerous to twist the exhaust valve of the high-pressure pump and suddenly pull out the connecting port between the pump and the oxygen cylinder. Orders will be processed instantly and dispatched in same day normally, so we do NOT accept any. We will reply your message within 48 hours. If you do not receive our reply within 48 hours, pls. Post a message again because sometimes our message system may block some emails. If you are satisfied with our service, pls. Our aim is to provide Top Level Customer Service, your recognition will encourage us greatly and serve you better. We strive to keep all our customers satisfy. We will always do our up most to exceed your expectations in customer service, communication and dispatching of your orders. The item “Oxygen Cylinder Scuba Diving Breathe Equip Air Tank & High Pressure Air Pump Kit” is in sale since Friday, March 15, 2019. This item is in the category “Sporting Goods\Water Sports\Scuba & Snorkeling\Tanks”. The seller is “storeshopping2014″ and is located in Hongkong. This item can be shipped worldwide.
- Brand: Unbranded
- MPN: Does Not Apply