110v/220v 300BAR 30MPA 4500PSI High Pressure Air Pump Electric Air Compressor for Pneumatic Airgun Scuba Rifle PCP Inflator. ISO VG46 Anti-Wear Hydraulic Oil(the machine is without of oil because the oil is not allowed on the plane). It takes 3 mins 50 seconds to fill full 0.45L tank to 30MPA. Mins to fill full 1L tank to 300BAR. This series are high pressure air compressor. Atmosphere air go to pressure 20/30Mpa, 3000/4500psi. After be purified and separated by the filter and separator. It is widely be used for breathing of diving and fire fighting. Paintball PCP shooting and other high pressure. Industries by its reliability, portability and easy to use. Make sure the voltage in nameplate meets local power. Make sure the lubricant has been put in before running. Make sure the pressure setting is under 4500psi (310bar). There is potential danger of pipe burst or connecting fitting. Blow off under high pressure, please avoid body too near. Compressor when it running. For safety Don’t leave compressor and always keep eyes. To look at until it reach rated pressure whether it is. Automatic stop or manual stop. For safety, always keep eyes on it until it reaches rated. Pressure and needs to stop. Double Check the lubricate oil has been put in before. Portable electric driven HP air compressor. Charging Rate:40-50L/min;1.5-1.8cfm. Of stage and cylinder:2. Electric motor:220v 50hz/110v 60hz, single phase. Shout down:manual stop/automatic stop(for optional). Lubricating oil:ISO VG46 or AW 46. Dimension:360 X 200 X 380mm. Noise:Less than 78 dB(A). Air hose connection: 8mm quick connect fitting. 3.1 Main components. Power no/off? Oil replace drain. Temperature gauge? High pressure hose. Pressure gauge? Quick connector. Water outlet? Intake air filter. Water inlet? Drain valve. Explosion-proof valve? 1st Safety valve. Pressure relief valve? Power cord socket. Oil level gauge? Water pump power socket. Atmosphere air is compressed through two stage cylinder to. Reach 20Mpa/30Mpa, 3000/4500 psi. And the air is filtrated by. Oil and moisture separator before filling in tanks. The condensate and oil are separate from air and drain from.